Antminer T9+ -BITMAIN- Sale, Repair, Upgrade Acceleration, Downvolt

Firmware Antminer T9+(18TH)

Energy-efficient firmware Antminer T9+ with extensive fine-tuning, manual and automatic settings.
Using the built-in profiles, the maximum acceleration mode for maximum performance or the downvolt mode for maximum energy efficiency.
The firmware has an intuitive interface, with support for ASICBOOST technology due to which energy consumption is reduced by an average of 20% and the stability of miners is increased.
Updated anti-virus protection blocks malicious software.
In the firmware, the developer has donat 2% of the total hashrate.
Installing and updating the firmware is possible through the "web interface" as well as using the SD card .


A familiar and convenient interface with a wide range of additional features of thin automatic and manual settings that allow you to fully open all the capabilities of your miners!
With the help of automatic tuning options it is possible to perfectly regulate energy efficiency and ASIC, so you get effective cooling of the device without the risk of overheating and an increase in productivity at the same cost of electricity.
In the visual settings tab, it is possible to adjust the frequency and voltage of each hash of the board and its chips according to a convenient color scheme, as well as identify problematic chips, domains with HW errors.
In the manual settings tab, it is possible to set the individual frequency and voltage of the hash boards, and it is also possible to disable polling of coolers for use in immersion fluid for maximum ASIC performance.
Continuous monitoring of chips and domains by temperature indicators and hash rate allows to keep the hash board temperature stable while avoiding sudden temperature changes, for stable ASIC operation.
The WatchDog watchdog algorithm controls the number of errors and hashrate, if necessary restarts the ASIC, preventing hashrate subsidence, overheating and Internet breakdown.
And it also controls the network and with long breaks in the Internet, asic goes into standby mode, turns off the power of the hashplat to prevent idle work and save energy.
The chip pre-heating mode has been introduced for operation in cold ambient temperatures; it allows the correct use of ASICs in northern regions at ambient temperatures below -15 ° C.
ASIC monitoring using LEDs on the ASIC front panel allows you to visually identify unstable working devices, as well as find the desired ASIC among other devices, this is convenient for data center farms with a large number of ASICs.
For convenient and fast firmware and protection against lowering and changing software.
Implemented the ability to flash using an SD card, which makes it easy to roll back the factory firmware .